SC-43A is manufactured in the USA and is RoHS compliant
The puller for tie rods and push rods of the series 129 is used for the hydraulic pressing out of the ball pins when removing ball joints on push and tie rods specifically designed for trucks and low-floor buses
series: 6300–6307
The pliers are handy and due to their lightweight adjustability
ensuring optimal performance and extended equipment lifespan
kukko 221-4 3-jaw puller with conical self-tensioning, up to 150 mm spread, 170 mm reach for centric removal of bearings, gears, and discs in all common sizes for crafts, workshops, and industr Nachi SC-43A is manufactured in theThe 3 jaw pullers with conical self tensioning are used for the centric removal of bearings, gears, and discs in all common sizes for crafts, workshops, and industry. This allows for the loosening of any component that sits on a shaft and is freely accessible from the outside. With the tightening of the tension cone, the puller jaws are automatically centered. By operating the tension cone, the desired spread can be adjusted. Additionally, the puller
