JTEKT-KOYO 6314-2RSC3 Deep Groove Ball Bearing - 70 mm ID, 150 mm OD, 35 mm Width loctit Charging Cable

Charging Cable

The ball joint puller of the series 127-A is used to press out the ball studs when removing ball joints and steering tie rod ends on tie rods

1 – 4CFM Vacuum Pump

000 A ± 0

The Whittet-Higgins SNS40-16S is a two-piece splitnut shaft locknut with a fine 16-threads-per-inch pitch

JTEKT-KOYO 6314-2RSC3 Deep Groove Ball Bearing - 70 mm ID, 150 mm OD, 35 mm Width loctit Charging CableDeep Groove Ball Bearing JTEKT KOYO deep groove ball bearings are versatile, robust, and accommodate radial and axial loads in both directions. Their simple design, low friction, and high speed capability make them suitable for a wide range of industrial applications, from electric motors to gearboxes. Sealed and shielded variants protect against contamination, while open versions allow easy lubrication.